Acu-rite 100S Manual de usuario descargar pdf (Pagina 34)

100S Reference Manual

TROUBLESHOOTING

A ROM memory error has occurred. Press the CLEAR

key to acknowledge the error. If the system does not

operate properly, contact your

100S distributor for

repair/replacement procedures.

A power loss has occurred. This message will appear

every time you power up the system and can be cleared

by pressing the

CLEAR key. If the E1 message appears

at any time other than at power up, a power interruption

has occurred and your current table position may be

lost. Re-establish the datum if necessary. If the problem

persists, contact your distributor for repair/replacement

procedures.

A random access memory (RAM) error has occurred.

Press the

CLEAR key to acknowledge the error and con-

tinue with the next test. If the system does not

operate properly, contact your

100S distributor for

repair/replacement procedures.

A scale miscount error (invalid waveform) error has

occurred. The E9 message will appear on the axis that

has the error. Press

CLEAR to reset the axis(es). Your

current position may be lost. Re-establish the datum if

necessary. If the system does not operate properly, con-

tact your

100S distributor for repair/replacement proce-

dures.

Error Messages (General)

When 100S is powered up, it will run a series of tests to ensure that the

software is working properly. If an error message appears, refer to the

charts on this page and the next for a diagnosis and solution.

An EEPROM memory error has occurred. Press the

CLEAR key to acknowledge the error. The datum and

setup information may be lost. These areas should be

checked and reestablished upon power up. If the problem

persists, contact your distributor for repair/replacement

procedures.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Sin comentarios

Acu-rite 100S Manual de usuario Pagina 34