Acu-rite 100S Manual de usuario descargar pdf (Pagina 12)

100S Turning Reference Manual

SETUP

Scale Resolution

To ensure accurate readings, the scale resolution shown for each axis must

correspond with the resolution of the scales on your machine.

o change the scale resolution:

• If necessary, choose “Scale Resolution” from the Setup menu.

(Press SETUP and then the ENTER key until the screen appears).

• Press the appropriate axis key (X, Y or Z) until the appropriate resolu-

tion appears. Choose 0.01 mm for 10µm (0.0005”) scales, 0.005 mm

for 5µm (0.0002”) and 0.001 mm for 1µm (0.00005”)scales.

• Repeat the procedure for each axis.

• Press

ENTER to continue with Setup.

Input 3 On/Off (2+ units only)

This parameter allows you to activate the third input. When this input

is enabled, Inputs 2 and 3 will be coupled on the Z-axis (both scales

will count on the Z-axis). The Input 3 scale must have the same scale

resolution as the Input 2 scale.

When Input 3 is enabled, additional parameters will need to be setup.

Refer to the procedures on pages 6-8 for setting up the Linear Error

Compensation and Count Direction Setup functions.

Position Recall

• Set this parameter to the ON position to store the last position

of each axis when power is turned off.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

Sin comentarios

Acu-rite 100S Manual de usuario Pagina 12