Acu-rite Micro-Line T Manual de usuario descargar pdf (Pagina 17)

MICRO-LINE Reference Manual

OPERATION

• Using the ABS/INCR key, select the absolute (ABS) mode. Also

check that the proper measurement (inch or mm) is selected.

• Using RAD/DIA key, select the Radius mode.

• Move the tool to a known point, i.e. the outside diameter of the

workpiece or the face of the workpiece.

• Press the ZERO key once for the axis (X or Z) for which you’re

entering a dimension.

• Using the keypad, enter the distance from your tool’s current

location to the point you want to establish as the datum. Include a

decimal point (.) and minus (-) sign when necessary.

• Press the ZERO key for the other axis, or press ENTER to return

to the DRO display.

To set the datum using an offset:

To set the datum at the tool’s current position:

• Position the workpiece in the chuck. Move the tool until

it is positioned at the location where you would like to establish the

datum.

• Using the ABS/INCR key, select the absolute (ABS) mode.

• Press the X-axis ZERO key twice to establish the current X-axis

position as the datum. Repeat for the Z-axis.

If you’re using 5µm (0.0002”) scales (international units only),

MICRO-LINE can recall your last datum position each time you power

up the system (refer to pg. 32 for the proper procedure).

MLTmanual.QXD 2/12/02 4:10 PM Page 31

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Sin comentarios

Acu-rite Micro-Line T Manual de usuario Pagina 17