Acu-rite Microscale Manual de usuario descargar pdf (Pagina 12)

• Check function of the linear encoder.

These steps will confirm proper operation of your installation.

Counting tests check channel A and B output function and Reference

Mark tests check Reference Mark operation.

• Configure the readout for proper counting resolution.

• Move axis and compare the display to the movement.

• Repeat test for mechanical integrity and repeatability.

• Configure the readout for sensing reference mark.

• Move the reading head approximately 20mm.

• Locate an indicator on scale end and zero out axis and indicator.

• Move axis out and back over full travel and return to dial zero.

• Electronics should read zero ± 1 count.

ACU-RITE

Checking the Installation MicroScale

• Zero the display and indicator.

• Move axis to the end of it’s travel, then return to dial zero.

• Readout should read zero ± 1 count.

Repeatability Test

Place indicator at end of

moving component (scale case

shown, or reading head).

• Route the cables with slack loops to allow for axis motion.

• Secure excess cable by fastening with clips or ties.

• Attach the linear encoder connectors to the readout.

Readout

Counting Test

Connecting

Secure excess

cable

Provide slack

loops

Attach connector

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Acu-rite Microscale Manual de usuario Pagina 12